Lionel stated the itty-bitty hole @ the grease zerk fitting on the nose fork appeared to be extremely small and was curious as to how much grease was actually getting on the entire bearing surfaces/innards.
Are you planning on enlarging the small hole to a larger diameter, in order to improve the grease flow on the nose fork bearing, or is it even possible?
If you're talking about that great big roller bearing on the steering collar, yes, it does only have one hole on the front through which you lube the bearing. I didn't think about it, but now that you mention it, it's definitely a good thought. I'll have a look at Lionel's thread, and take a look at the collar and see what I can come up with. That's an awefully large bearing ($$$$$) with minimal means to get the grease in there. Good point. I'll let you know what I come up with.
